Vaporesso XROS COREX 2.0 Mesh Pods 0.7 Ohm 3ml 4pcs

The Vaporesso XROS COREX 2.0 Mesh Pods 0.7 Ohm are refillable replacement cartridges for devices in the XROS Series. The coil is permanently integrated into the pod, so the complete cartridge is replaced once the coil reaches the end of its usable life.

Each pod has a 3ml e-liquid capacity, providing a useful liquid reserve for regular use with a Vaporesso XROS device.

A key characteristic of this COREX 2.0 version is the side filling system. Unlike newer COREX 3.0 pods with top filling, the 0.7 Ohm pod is refilled through an opening on the side of the cartridge.

To refill, remove the pod from the XROS device and carefully open the side rubber plug. Add e-liquid slowly through the dedicated filling port, then press the rubber seal fully back into position.

Avoid overfilling the pod. After filling, check the filling port and electrical contact area for any remaining e-liquid and wipe them dry if necessary.

An integrated 0.7 Ohm mesh coil using COREX 2.0 technology is built into the cartridge. The mesh structure distributes heat over a larger surface area and supports even vaporisation and consistent flavour delivery.

At 0.7 Ohm, this version sits between the commonly used 0.6 and 0.8 Ohm XROS pods. Depending on the XROS device and airflow setting, it provides a balanced draw ranging from loose MTL to a slightly more open vaping style.

XROS pods use a design intended to reduce leaking. However, no refillable pod is completely leak-proof. E-liquid viscosity, temperature, filling method, storage position and pod condition can all affect condensation and sealing performance.

The XROS COREX 2.0 0.7 Ohm Pod is compatible with devices in the Vaporesso XROS Series, allowing this side-fill COREX 2.0 version to continue being used within the wider XROS ecosystem.

When filling a new pod for the first time, allow sufficient time for the e-liquid to saturate the cotton. We recommend waiting approximately 5–10 minutes before first use to help reduce the risk of a dry or burnt taste.

Vaporesso gives a typical replacement interval of approximately 1–2 weeks for XROS pods depending on use. This is not a fixed service life. Actual pod longevity depends on factors including e-liquid composition, sweetness, frequency of use and individual vaping style.

The pod should be replaced when flavour noticeably decreases, a burnt or unusual taste develops, vapour production becomes inconsistent or the cartridge no longer performs reliably despite correct filling.

Highly sweetened or heavily flavoured e-liquids may place greater stress on the integrated coil and can therefore shorten pod life.

As the coil and cartridge form a single unit, there is no separate coil to replace. Once worn, the complete pod is removed and replaced with a new Vaporesso XROS COREX 2.0 0.7 Ohm Pod.

This product contains no e-liquid and no nicotine.

Package contents:
4 x Vaporesso XROS COREX 2.0 Mesh Pod 0.7 Ohm, 3ml

Notice:

Small amounts of condensation may occur during normal use of refillable pods. The pod and electrical contacts should therefore be checked regularly and wiped dry when required.

For hygiene reasons, opened or used pods are excluded from exchange or return unless a product defect is present.